RSS feed
  • How to Inspect a Deck in Tacoma, WA

    Posted on September 11th, 2022 mywp-admin No comments

    When inspecting the deck, you should pay attention to small details. For example, make sure the railings are vertical and upright. Also, check the stringers that support the stairs. If you see a crack in one of these areas, review the fasteners to ensure they are in place. Rotted pins can cause your deck to collapse or pull away from the house.

    Another essential feature is the ledger, a support beam that secures the deck to the house. Make sure it’s tight against the house and use the proper spacing. Flashing should also be used to protect the ledger from moisture. Support beams should be at least six inches wide. The length of these supports should not exceed 12 feet. You can use cross-bracing to extend them to a maximum of 14 feet.

    Before stepping on the deck, check for cracks, gaps, or other damage. Cracked or loose boards can cause the wood to rot below. It’s best to hire a professional to check these areas. Also, check the joists and posts. They’re made of wood, so they’ll be more susceptible to water damage.

    During an inspection, a home inspector will examine the footing and framing. The inspector will check for proper spacing and the type of wood used throughout the structure. The inspector will also look for appropriate fasteners. In addition, the inspector will check if the railings are secured securely.

    The footings are the main component of the deck’s foundation. They secure the deck to the ground and support it. If they are not large enough to keep the deck, it’s a sign that it is not adequately supported. Another sign of compromised footings is cracked concrete around the footings.

    Joist hangers should be spaced every 16 inches or so. It’s not code-compliant to space joists more than this. In addition, the spacing between deck boards and posts must be exactly 16 inches, or you’ll see spongy wood, cracks, and uneven joints. Also, check for wood splinters. If you can, use an awl to test the deck’s lumber.

    If there are any loose fasteners, you should replace them with new ones. You should also check the ledger board, which is the rim board attached to the house. You may need to install additional pier supports if the board is loose. If the board has any exposed wires, they should be cleaned with water and soap.

    The ledger board should also be attached to the house with hex bolts or lag screws. If it’s not, you should consider having a qualified deck contractor retrofit the connection. The only exception to these standards is when a deck is attached to the house using nails. In this case, there’s a significant risk of collapse, which could cause injuries to people on the deck.

    Check also deck inspection for more information.

Comments are closed.